Cleaning and Storage
195
Lubricate and if necessary adjust the
Make sure the cooling system is filled
with a 50% mixture of coolant (noting
that HD4X Hybrid OAT coolant, as
supplied by Triumph, is pre-mixed and
requires no dilution) and distilled water
Remove the battery, and store it where
it will not be exposed to direct sunlight,
moisture, or freezing temperatures.
During storage it should be given a slow
charge (one Ampere or less) about once
every two weeks (see page
173).
Store the motorcycle in a cool, dry area,
away from sunlight, and with a minimum
daily temperature variation.
Put a suitable porous cover over the
motorcycle to keep dust and dirt from
collecting on it. Avoid using plastic or
similar non-breathable, coated materials
that restrict air flow and allow heat and
moisture to accumulate.
Preparation after Storage
Install the battery (if removed) (see
If the motorcycle has been stored for
more than four months, change the
Check all the points listed in the Daily
Safety Checks section.
Before starting the engine, remove the
spark plugs from each cylinder.
Put the side stand down.
Crank the engine on the starter motor
several times until the oil pressure light
goes out.
Refit the spark plugs, tightening to
12 Nm, and start the engine.
Check and if necessary correct the tyre
pressures.
Clean the entire vehicle thoroughly.
Check the brakes for correct operation.
Test ride the motorcycle at low speeds.