Maintenance
181
Caution
Do not cover the headlight or lens with
any item likely to obstruct air flow to,
or prevent heat escaping from, the
headlight lens.
Covering the headlight lens during
operation with items of clothing,
luggage, adhesive tape, devices
intended to alter or adjust the
headlight beam or non genuine
headlight lens covers will cause the
headlight lens to overheat and distort,
causing irreparable damage to the
headlight assembly.
Damage caused by overheating is not
considered a manufacturing defect and
will not be covered under warranty.
If the headlight must be covered
during use - such as taping of the
headlight lens required during
closed-course conditions - the
headlight must be disconnected.
Headlight Adjustment
LED Headlight Unit
The headlight can be adjusted by means
of a vertical adjustment screw located
on the rear of the headlight unit. There
is no horizontal adjustment. In addition,
the headlight is equipped with an easily
accessible adjuster to allow the vertical
adjustment to be corrected when the
motorcycle is fully loaded.
ckdt
1
2
1. Headlight adjuster lever for loaded
conditions
2.
Vertical adjustment screw
To adjust the headlight:
• Switch the headlight dipped beam
on.
• Turn the vertical adjustment screw
on the headlight unit clockwise to
raise the beam or anticlockwise to
lower the beam.
Note:
• There is a small triangle marking on
each side of the headlight unit
which indicates the height of the
light within the headlight unit for
adjustment purposes.
• Switch the headlights off when the
beam settings are satisfactory.
