27
4.6 PHONO Module
The PHONO module can be connected to a turntable with MM or MC pickup. The
impedance matching of the pickup is made on the rear of the module by subminiature
switches. Please refer to the tables [
A
] and [
B
] for the adjustable values.
Also, the gain of the PHONO module must be adapted to the used pickup. This
setting is made on the front of the
Epilog
. Two PHONO modules can be installed
in the
Epilog
.
4.6.1 The Necesscary Software
To operate the PHONO module, the
Epilog
requires the firmware with the version
V0.10 or higher. If the installed firmware is "older" than V0.10 (
the number is less than
0.10
), so you need only perform an update. (See section 4.1)
4.6.2
The connectors on the back
PHONO MM/MC
D ia l o g
L
R
O
N
D
IP
1
2
3
4
5
6
7
8
O
N
D
IP
1
2
3
4
5
6
7
8
1
3
2
5
4
To the RCA connectors [
1
] and [
2
] the record player are connected. Normally
turntables have a separate ground wire. This cable must be connected to the screw
terminal [
4
] (Ground socket).
The two switch banks [
3
] and [
5
] are used to separate channel impedance matching
of the connected pickup. Each switch bank has 2 switches for capacitive adaptation
of a MM pickup and 6 switches for adjusting a MC pickup.
4.6.3
The settings and menus
