Here the power cord is plugged. Always pay attention to the correct mains voltage.
As standard, the epilogue is set for a mains voltage of 230 V AC. Have been set the
Epilog
for different voltages, then corresponding notes are (sticker) at the amp.
(
25
)
IR-CON Jack
An external IR controller can be connected to this jack. If the
Epilog
is situated at
a place where he can not receive infrared remote control commands, these
commands can be leaked via a small external IR receiver. This receiver is available
as an optional accessory.
(
26
)
USB-SERVICE Jack
Over time, other new modules are developed, which however, always need the right
software to control. So if like to use a later newly developed module in your
Epilog
, we created an opportunity to update the control processor with the
currently valid software. Please note that you find the latest software version at our
web site. There is the current software version available for download.
In the
Epilog
SET menu is a submenu "Info" where you can get information about
the currently software version of your
Epilog
.
The required software for the update procedure and a detailed description of that
procedure is also made available on our Website.
(
27
)
REMOTE 10V Jacks
If you have connected to the
Epilog
another power amp or active Subwoofer, and
this amp has a DC 10V remote input, an additional 10V DC signal is available at this
jack to switched on and off synchronous with the
Epilog
.
3.3 Quick Start Instructions
For the impatient among you who already have some experience with high-end
amplifiers, here's a short guide to get to the music quickly:
•
Hook up all devices
•
Connect to AC mains and switch on the power switch (
23
) on the mains power
switch.
•
Turn the
Epilog
on with the standby switch (
1
)
•
Select source device with the input selector buttons (
7
) and (
8
)
•
Set desired listening level with volume knob (
3
)
•
Done!
