TRC 1000 4.5 Hot cutter, Руководство по обслуживанию

Страница: 39 / 67

39
removed, the assembly should move so the trip rod falls down into the notches on the
side plates, actuating the switch. Some adjustment may be necessary to get this to
work correctly.
• Machines that were purchased without cutoff switch will have the guide plate installed
with the trip rod groove facing down. After installation of the Cutoff Switch, the guide
plate should be re-installed with the groove facing up to accommodate the trip rod.
This grove will align with the groves on the side plates.
• Tighten all loosened screws.
• Using a multimeter, check that the control cable has pins 5 and 12 connected through
to each end.
• Re-apply power and test cutting unit for proper operation. Unit should stop when trip
rod is down.
An “OUT OF MATERIAL” message will appear when cutoff switch is
activated. To continue cutting, replenish machine with material.
• Be sure to remove any remaining partial sections of material from machine before
resuming cutting operations. Use the feed jog once material is inserted into the rollers to
advance material past the cutter blade. Perform the cut jog function to set the first cut.
• Press enter key to resume operation.
• The piece count will continue wherever the machine left off before running out of
material.
Adjusting LCD Contrast
The LCD Screen on the Circuit Board can be adjusted via the variable resistor, shown in the
photo below.
• Begin by removing power to the control panel and disconnecting from cutter head.
Variable
Resistor