TRC 1000 4.5 Hot cutter, Руководство по обслуживанию

Страница: 13 / 67

13
2. Connect the air regulator to the cutter head via the press to lock fittings. Set the air
supply pressure at 60 PSI. If connected correctly the blade carrier should move to the up-
stroke position.
3. Set the roll stand on the infeed side of the cutter and line it up with the guides. Place
one plastic disk on the roll stand shaft, then feed webbing roll on to shaft so webbing rolls off
the top side of the roll. Place the other plastic disk on the roll stand and put the roll holder
collar lightly against the disk. tighten the thumb screw lightly. If the webbing does not turn
freely, loosen the roll holder a little.
Start Up Procedures
• Adjust the guide strips to fit the webbing you are using. Do not make it too tight as to
cause drag on the webbing. The guide strips are there to simply funnel the material
towards the rollers.
• Turn master switch to the ON position.
• Feed the webbing through the guides and push it up to the feed rollers and then push
the FEED JOG button on the control panel. This will take the webbing through the feed
rollers. Take the webbing past the rollers an inch or so. You can also put the webbing
through the rollers by pushing down on the black knob and lifting the rollers and
pushing the webbing through.
Note: If your machine is equipped with the optional cutoff switch, you must feed material
under the trip rod before the guides.
Keyboard Commands
FEED JOG Allows you to manually operate the feed rollers
KNIFE JOG Allows you to manually operate the knife
RE-SET Allows you to clear the machine and start a new program
STOP Allows you to stop the machine and save all data in the memory. The STOP function
Also allows you to clear a data entry while programming
– for example, if an incorrect value
was entered for length or cut time.
ENTER Allows you to enter program data
Entering a Program
Feed Rate