TRC 1000 4.5 Hot cutter, Руководство по обслуживанию

Страница: 8 / 67

8
Setting Up and Using your new TRC 1000 Series Strip Cutters
Model HC4 and HC7 Setup
1. Place control panel and cutter on a flat table with the back of the control panel facing
the side of the cutter. Plug the black heater cord cable from the cutter into the control panel.
Next, connect the control panel to the cutter using the grey control cable. Plug the power
cord into the fused power receptacle on the control panel and the other end into a standard
120V single phase receptacle.
BE SURE ALL CABLES ARE SECURELY FASTENED BEFORE TURNING ON THE POWER!
2. Connect the air regulator to the cutter head via the press to lock fittings. Set the air
supply pressure at 40 PSI. If connected correctly the blade carrier should move to the up-
stroke position.
3. Set the roll stand on the infeed side of the cutter and line it up with the guides. Place
one plastic disk on the roll stand shaft, then feed webbing roll on to shaft so webbing rolls off
the top side of the roll. Place the other plastic disk on the roll stand and put the roll holder
collar lightly against the disk. tighten the thumb screw lightly. If the webbing does not turn
freely, loosen the roll holder a little.
Start Up Procedures
• While the machine is cold, adjust the guide strips to fit the webbing you are using. Do
not make it too tight as to cause drag on the webbing. The guide strips are there to
simply funnel the material towards the rollers (figure 2).