TRC 1000 4.5 Hot cutter, Руководство по обслуживанию

Страница: 15 / 67

15
Cut Time
Figure 10
Next, “Cut Time?” will appear on the LCD. This is amount of time in seconds the blade will
cycle for. The maximum time that most cutters can cut for is 2.4 seconds, but this varies
depending on chip version. We recommend starting at 0.5 seconds an increasing as
necessary. A decimal can be entered by pressing the “*” key. Cut times will vary with the
thickness of the webbing and some trial and error is necessary to get the proper cut time.
How Many
Figure 11
This is the number of pieces that you want to cut. BEFORE you push enter on How many, you
will want to insert the material through the feed guides, pushing it up to the feed rollers. Press
and hold the FEED JOG button until material advances past the cold knife about 3". Press the
KNIFE JOG button and cut off the webbing. This will give you a fresh cut to start with.
Now with the correct piece count entered in press ENTER and the machine will start cutting.
When the number of pieces that were entered have been cut the machine will stop. If you
wish to run the same program again just push ENTER and it will run the same program again,
while maintain a running count of both program runs.
Stopping the Machine
To stop the machine during operation and not lose the data you have entered, push the STOP
button and hold it down until the machine stops.
In the event of an emergency, simply turn the master power switch to the off position.
By using the STOP button, you will save the program and the count. To start the program again
just push ENTER and it will continue with the program you had entered. When you use RESET or
the master switch you will lose the program, meaning you will have to follow the prompts
again and enter the desired program values in again.