42
It can be accessed by prying the tray open with a small flat blade screwdriver. The two-part
tray will come out. To separate the two parts of the inner tray, lift up on the black clip, shown in
the photo below, and pull out on the inner section of the tray.
With the inner section of the fuse tray removed, the fuse is now accessible. The fuse can be
tested for continuity while in tray. A small screwdriver can be used to pry the fuse out. Note
that fuses may appear intact, so a continuity test is the only way to determine if the fuse is
operational. There should only be one fuse in the tray. Most machines with this tray type use an
8 amp slow blow fuse. These are not typically found in automotive or hardware stores
anymore. This type us used because it can accept some small variation in voltage without
blowing immediately.
Lift tab,
Pull tray
Содержание 1000 4.5 Hot cutter
