TRC 1000 4.5 Hot cutter, Руководство по обслуживанию

Страница: 11 / 67

11
The Next prompt will be for length(figure 4). Type in the desired length and press ENTER. For
example, 15 inches will be typed in as “15”. For decimal values, use the “*” key. For example,
15.5 inches would be typed as “15*5”
Cut Time
Figure 5
Next, “Cut Time?” will appear on the LCD (figure 5). This is amount of time in seconds the blade
will stay in the down position for. The maximum time that most cutters can cut for is 2.4
seconds, but this varies depending on chip version. We recommend starting at 0.5 seconds an
increasing as necessary. A decimal can be entered
by pressing the “*” key. Cut times will vary
with the thickness of the webbing and some trial and error is necessary to get the proper cut
time. 1" medium weight poly pro webbing will cut in about .75 seconds or 3/4 of a second.
How Many
Figure 6
This is the number of pieces that you want to cut (figure 6). After typing in a number and
BEFORE you push the
Enter key you will want to insert the material through the feed guides,
pushing it up to the feed rollers. Press and hold the FEED JOG button until material advances
past the hot knife about 3". Press the KNIFE JOG button and cut off the webbing. This will give
you a fresh cut to start with.
Now with the correct piece count entered in press ENTER and the machine will start cutting.
When the number of pieces that were entered have been cut the machine will stop. If you
wish to run the same program again just push ENTER and it will run the same program again,
while maintain a running count of both program runs.