Maintenance
41
© Travis Industries
9/17/2020 - 1536
DVL EG GSR2
Loosen the two screws nearest the bulb to disengage the
bulb from the holder. Remove the bulb from the holder.
Replace the bulb, making sure not to touch the bulb with
your fingers (grasp the bulb with the bulb packaging or a
paper towel). Tighten the screws until the bulb is secure
(do not over-tighten, this may damage the electrical
contacts on the bulb).
The accent light in your heater provides additional
lighting. The bulbs will burn out over time. To replace,
follow the directions below:
Shut off gas to the heater and let it cool for 15
minutes.
Remove the glass (see page 25) and media.
Replace the halogen bulbs with the following bulbs:
NOTE
: Take care to not touch the bulbs with your fingers – use foam packing or a paper towel to handle the bulbs:
35 Watt 120 Volt T4 Halogen Bulb (GY6.35 Base)
Ember-Glo Bulb Replacement
The Ember-Glo lights in your insert provide additional lighting and a more realistic fire appearance. The
bulbs will burn out over time. Replace the halogen bulbs with the following bulbs:
NOTE
: Take care to not touch the bulbs with your fingers – use foam packing or a paper towel to handle the bulbs:
35 Watt 120 Volt T4 Halogen Bulb (GY6.35 Base)
To replace, follow the directions below:
1. Shut off gas to the Insert and let it cool for 15 minutes.
2. Remove the glass assembly (see page 25).
3. Remove Ember Glass, Ember Nuggets from the media tray.
HINT
: It is easier to remove the media tray if
you first remove the (4) logs indicated
below.
4. Lift the media tray skirt upward and remove it from the firebox.
Micro (1/16") Standard
or Philips Screwdriver
Do not loosen these screws
(they hold the wires in place).
