Operation
31
© Travis Industries
9/17/2020 - 1536
DVL EG GSR2
Synchronize the Transmitter to the IFC
The transmitter will need to be synchronized to the IFC (Integrated Fireplace Control) before the remote
will work correctly. Synchronizing is done in the following two steps below (see
Figure 2
):
13. Press the PRG (Program) button on the battery box (IFC will beep 3 times).
14. Press the “ON” button on the transmitter (IFC will beep 3 times).
Figure 2
NOTE
: If power is cut off to the IFC for an extended period, you may need to re-synchronize the remote.
Clearing the System Memory
This appliance uses an Integrated Fireplace Control (IFC) to store the unique code for the remote control.
If you wish to clear the system memory,
MAKE SURE GAS IS TURNED OFF TO THE APPLIANCE
then
press the PRG (Program) button for 10 seconds. The pilot will start to spark repeatedly, signifying all
system memory has been cleared. The system will return to its original configuration: a remote will need
to be synchronized; and, the system will operate under continuous pilot mode.
Direct Operation
The fireplace may be directly operated from the battery holder. The three positions are below (see
Figure 3
):
ON
– Burner turns on (regardless of transmitter settings).
OFF
– Burner turns off (regardless of transmitter settings).
REMOTE
– Burner is controlled by the transmitter.
Figure 3
NOTE
: When the battery holder switch is turned to ON or OFF, the mode settings (Flame Height, Comfort
Control) will remain in the same state as before the switch was moved (i.e.: the IFC “remembers” the last
setting). If you wish to adjust the mode settings use the transmitter mode button to adjust the settings
(see “Mode Controls” on page 36). The thermostat and burner on/off operating functions will not work on
the transmitter.
°F
"Beep"
"Beep"
"Beep"
"Beep"
"Beep"
"Beep"
ON REMOTE OFF
