User Guide
TransCore Proprietary
5-2
System Test Procedures
This chapter provides testing procedures that will help you fine-tune your reader system and test basic
operation, measure radio frequency (RF) power, measure system noise, read tags, and monitor the
system.
Required Tools and Equipment
The following tools and equipment are required:
•
50-ohm, 5-watt (W) load (N-type connector)
•
Personal computer (PC) with terminal emulator software
•
Appropriate power source for your reader
•
Digital multimeter
•
Antenna, cable, and connectors
Testing Basic Operation
To test the system operation, configure the reader system as follows:
1. Configure a terminal emulator (a PC using communications software) to 9600 baud, no parity, 8 data bits,
and 1 stop bit (factory default settings for the reader).
2. Connect the emulator to the main RS–232 interface located on the front panel of the reader system.
3. Slide the Interface Selection switch on the front panel of the reader to
RS232.
4. Switch the ON/OFF switch located on the front panel of the reader system to
off.
5. Connect a power source to pins 1 (+) and 3 (-) on the DC power input front panel connector (
Figure 5 – 1
).
Figure 5 – 1 Power Source Connections
6. Switch the ON/OFF switch located on the front panel of the reader system to
off
.
7. Type the command
!01 or ~~CC
(CC must be entered in upper case) and press
Enter
.
Note: For information on entering command codes, refer to
“Communications Protocols” on page
6-2.
1
2
3
Chassis (GND)
-VDC
+12 to +150VDC
Содержание 1422E
