TRADEDOR TD77DM, Руководство по установке

Страница: 10 / 44

Tradedor TD77DM & TD77SEL Installation Guide
1 Place your hop ups / step ladders and one
guide runner each side of the opening.
2 With one person each end, lift the header
assembly by the header plate up and
into place, then guide the locating stem
at each end into the hollow section of
guide runners (this can be made easier by
slightly angling the header if there is not
enough room to simply drop the locating
stem in)
(fig.4.1) .
3 Lift the whole unit flush into place and check
that the top box and guide runners are
plumb level and square
(fig.4.2 & fig.4.3) .
4 Drill a 7mm fixing through the top hole
in the guide runners and secure into
place
(fig.4.4) .
5 Check the case and guide runners are still
level and square, then proceed to drill
a 7mm fixing through the remaining holes,
remembering to check the guide runners
are square and plumb after each fixing.
6 Once the guide runners are fixed you will
need to secure the top box. This is best
done through the end flanges of the header
plate, either forward or sideways through
the header plate itself if a between fixing
(fig.4.5) .
7 Check to make sure all fixings have not
caused the front fascia to be pulled in,
as this will rub against the slats causing
damage and scratching to the face.
8 Seal down the sides and along the top
case (silicon sealant is recommended).
fig.4.1
fig.4.3
fig.4.5
fig.4.2
fig.4.4
9
4. Installing Header Assembly