TRADEDOR TD77DM, Руководство по установке

Страница: 24 / 44

Tradedor TD77DM & TD77SEL Installation Guide
1 Once installation is complete and before
powering up, slide back down dip switch ‘2’ in
the control panel, this can be found on the four
dipswitch block at the bottom middle of the
receiver board (usually blue or red)
(fig. 9.1) .
2 For access to the base rail unit on the right side
(where the writing is), push at the end of the
grey cover and slide to the left. This will give
access to the board
(fig.9.2) .
3 Remove the plastic tab from the batteries
and the LEDs will blink on the safety edge unit.
4 Inside the receiver box press and hold the
“PROG” button on the receiver card (this is the
card plugged onto the board) until you hear
a single beep
(fig. 9.4) , then press and hold
the “PROG” button on the wireless safety edge
(fig. 9.3c) and you will hear another beep
from the receiver box.
5 Wait several seconds until you hear 2 beeps
from the receiver box and pairing is complete.
fig.9.1
fig.9.2
PUSH
GREY
SECTION
Programming Base Rail Unit
(SAFETY EDGE)
23
11. Setting Up Wireless Safety
Edge Kit
(OPTICAL EDGE)
- TYPE 1