TRADEDOR TD77DM, Руководство по установке

Страница: 8 / 44

Tradedor TD77DM & TD77SEL Installation Guide
1 Both guide runners will be marked
with the letter ‘F’ to indicate the front.
This has the flat face when looking in
the rear box section of the guide runner
(fig.3.1) . It will fit against the wall for a
behind fixing or face out of the garage
for a between fixing.
2 Measure from floor to lintel and refer to
diagram 2 , checking the lintel is level.
Your guide runner will be oversized, make
sure you cut the guide runners to size
as needed using a hack saw, for best
results cut the end which will be the
bottom
(fig.3.2) .
3 Offer both cut guide runners up against
the walls they will be fixed to and mark
the fixing points, either on the flat face
for a behind fixing (fig.3.3) or for a
between fixing in the opening (fig.3.4) .
For best results these should be as
follows;
A Top fixing between 50mm to
100mm down from the top of
the guide rail.
B Bottom fixing 50mm to 100mm
up from the floor.
C Marking at least one other fixing,
spread these evenly between the
two already marked points on the
guide runners so that you have
a secure fixing.
D Drill a 7mm hole all the way
through each of the marks on
the guide runners and then drill
a 10mm hole to countersink
through the first layer only so you
can get the screw head through.
fig.3.1 -
Please be aware that guide rails may vary in profile from picture
fig.3.2
fig.3.4
fig.3.3
Front Face
7
3. Preparing Guide Runners
For Installation