TRADEDOR TD77DM, Руководство по установке

Страница: 23 / 44

Tradedor TD77DM & TD77SEL Installation Guide
12 Press the up button on receiver box so the curtain
starts to roll up around the barrel and is lifted off
of the tool box, once this has happened press stop
and remove the tool box.
13 Place the plastic wand in to the limit nearest
you inside the garage
(fig. 8.8) and turn 10
times in the negative direction (this is marked
on the head of the motor near limits)
(fig. 8.10) .
14 Press the down button so the door closes, it should
stop before it touches the floor. If this is not the
case, take the door back up 300mm off the floor
and turn again 15 times in the negative direction
and take the door back down. Repeat until the door
does stop before it reaches the floor.
15 Whilst holding the down button turn the wand
in the positive direction and the door will start to
judder down. Keep going until the door slats are
fully compressed and a little pressure is applied
from the top (don’t apply too much pressure as
this will damage the door and straps). Take the
door up a little and back down to make sure you
are happy.
16 Place the plastic wand in to the other limit
nearest the guide rail/curtain of the door and
turn 15 times in the negative direction.
17 Press and hold the up button and the door will
travel to the top and should stop on its own.
If the door gets to 100mm from the top of the
guides (roughly 2 slats) and hasn’t stopped,
stop the door and take it back down to 350mm
from top of the guides (roughly 6 slats), turn
again 15 times in the negative direction and
take the door up. Repeat until the door does
stop before it gets to 100mm from top.
18 Whilst holding the up button, turn the wand in
the positive direction and the door will start to
judder up. Keep going until there is only the last
slat in the guides. Take the door down a little
and back up to make sure you are happy.
19 Close the door down to make sure the curtain doesn't
catch anywhere and the front case is not bowed
in so as to rub on the curtain during operation,
then seal down the sides and along the top case
if needed (silicon sealant is recommended).
fig.8.11
fig.8.12
fig.8.13
22