TRADEDOR TD77DM, Руководство по установке

Страница: 16 / 44

Tradedor TD77DM & TD77SEL Installation Guide
15
1 Open the lid of the receiver box by unscrewing the
four screws (one in each corner)
(fig.7.1) .
2 Remove the two screws from the bottom of the
box (these can be found behind the glands) and the
wall mounting plate can be removed from the back
(fig.7.2 & 7.3) .
3 Making sure the fixing plate is square with the screw
fixings at the bottom, mark the four fixings points.
This should be at a comfortable height to operate the
push buttons but out of the easy reach of children -
between 1500mm from the floor and 300mm down
from the roof/ceiling is recommended. Drill and then
secure in place
(fig.7.4) .
4 Hook the top of the receiver box on to the wall fixing
plate with the cable glands pointing downwards and
secure with the two screws.
5 Run the two core cable from the safety brake end across
to the same end as the receiver box making sure to securely
fix the cable out of the way of the working mechanism
(usually on top of the casing).
6 Remove the green 5 terminal block in the bottom left
corner
(fig.7.5) and you will see letters printed on the
circuit board.
7 Wiring as follows:
fig.7.1
fig.7.2
fig.7.3
Mains Power:
N – Neutral / Blue 3 core cable (power)
L – Live / Brown 3 core cable (power)
Earth – connect power cable directly to
earth from motor in plastic connector.
Motor:
U – Brown 4 core cable (motor)
V – Black 4 core cable (motor)
Earth - connect motor cable directly
to earth from motor in plastic connector.
W[c] – Blue 4 core cable (motor)
Safety Brake:
Remove black link wire from far right hand side stop
terminal, and replace with Brown (2 core cable)
and Blue (2 core cable), one each side
(fig.7.5) .
9. Installing Receiver Box
(SAFETY EDGE)
- TYPE 1