Optional Devices
Portégé A100
8-8
Portégé A100
Version
2
Last Saved on 25.11.2003 16:23
ENGLISH using Palau30 Online.dot –– Printed on 28.11.2003 as
Seating the memory module
10. Seat the insulation sheet to cover the module.
Be sure to check that insulation sheet is returned to the original position
to cover the memory module.
11. Rotate the keyboard into place. Fasten the two screws you removed
in Step 6.
12. Set the keyboard brace into its groove and press down to secure the
latches.
13. Turn the computer upside down and replace the Battery pack. (refer
to Chapter 6,
Power and Power-Up Modes
)
14. Turn the computer on and check the memory. Open the
System
Properties
icon in the Windows
Control Panel
and click the
General
tab.
Removing memory module
To remove the memory module, make sure the computer is in boot mode
then:
1. Be sure the power is off and all cables are disconnected from the
computer.
2. Turn the computer upside down and remove the Battery pack. (refer
to Chapter 6,
Power and Power-Up Modes
)
3. Follow the instructions 4 through 8 in “Installing memory module” to
appear memory module.
4. Push the latches to the outside to release the module. A spring will
force one end of the module up.
5. Grasp the sides of the module and pull it out, then replace the
insulator.
S
LOT
A
S
LOT
B
