Toro Multi Pro WM 41240, Руководство оператора

Страница: 75 / 84

10. If you loosened the mounting hardware for the
bypass fitting, tighten the nut and bolt to 1017 to
1243 N-cm (90 to 110 in-lb).
Installing the Valve Actuator
1. Align the actuator to the manifold valve and
(
Figure 87 ).
2. Secure the actuator and valve with the retainer
that you removed in step
3 of Removing the
Valve Actuator (page 66) .
3. Connect the 3-pin connector of the valve
actuator harness to the 3-socket connector of
the wiring harness of the sprayer.
Storage
1. Position the sprayer on a level surface, set the
parking brake, stop the pump, stop the engine,
and remove the key from the
STARTER
switch.
Note:
For HD- and HDX-Series Workman
models with a manual transmission, disengage
the PTO
2. Clean dirt and grime from the entire machine,
including the outside of the cylinder-head fins of
the engine and blower housing.
Important:
You can wash the machine
with mild detergent and water. Do not use
high-pressure water to wash the machine.
Pressure washing may damage the electrical
system or wash away necessary grease at
friction points. Avoid excessive use of water,
especially near the control panel, lights,
engine, and the battery.
3. Condition the sprayer system as follows:
A. Drain the fresh water tank.
B. Drain the spray system as completely as
possible.
C. Prepare rust inhibiting, non-alcohol
based, RV antifreeze solution per the
manufacturer's instructions.
D. Add the RV antifreeze solution to the fresh
water tank and the sprayer tank.
E. Run the sprayer pump for a few minutes
to circulate the RV antifreeze throughout
the sprayer system and any installed spray
accessories.
F. Drain the fresh water tank and spray system
as completely as possible.
4. Use the
BOOM
-
LIFT
switches to raise the booms.
Raise the booms until have moved completely
into boom transport cradle forming the “X”
transport position and the boom cylinders are
fully retracted.
Note:
Make sure that the boom cylinders are
fully retracted to prevent actuator rod damage.
5. Perform the following maintenance steps for
short-term or long-term storage
•
Short-term storage (less than 30 days),
clean the sprayer system; refer to Cleaning
the Sprayer (page 52) .
•
Long-term storage (longer then 30 days),
perform the following:
A. Clean the sprayer valves; refer to
Cleaning the Sprayer Valves (page 66) .
B. Grease the sprayer; refer to Lubrication
(page 61) .
75