Toro Multi Pro WM 41240, Руководство оператора

Страница: 48 / 84

Preparing to Use the
Sprayer
Cleaning the Suction Strainer
Service Interval: Before each use or daily Clean the
suction strainer more often when
using wettable powders.
1. Position the sprayer on a level surface, set the
parking brake, stop the pump, stop the engine,
and remove the key from the
STARTER
switch.
2. At the top of the sprayer tank, remove the
retainer that secures the hose fitting attached to
the large hose from the strainer housing (
Figure
66 ).
g002257
Figure 66
1. Suction hose 2. Retainer
3. Remove the hose and hose fitting from the
strainer housing (
Figure 66 ).
4. Pull the suction strainer out of the strainer
housing in the tank (
Figure 67 ).
g005491
Figure 67
1. Suction strainer
5. Clean the suction strainer with clean water.
6. Insert the suction strainer into the strainer
housing until the strainer is fully seated.
7. Align the hose and hose fitting to the strainer
housing at the top of the tank, and secure fitting
and housing with the retainer that you removed
in step
2 .
Inspecting the Tank Straps
Service Interval: Before each use or daily—Check
the tank straps.
Important:
Over-tightening the tank strap
fasteners can result in deforming and damaging
the tank and straps.
1. Fill the main tank with water.
2. Check to see if there is any movement between
the tank straps and the tank (
Figure 68 ).
g028263
Figure 68
1. Rear tank strap 4. Forward tank strap
2. Bolt 5. Front of the machine
3. Flanged locknut
3. If the tank straps fit loose to the tank, tighten the
flanged locknuts and bolts at the top of straps
until the straps are flush with the surface of the
tank (
Figure 68 ).
Note:
Do not over-tighten the tank strap
hardware.
Operating the Sprayer
To operate the Multi Pro WM first fill the spray tank,
then apply the solution to the work area, and finally
clean the tank. It is important that you complete all
3 of these steps in succession to avoid damaging
the sprayer. For example, do not mix and add
chemicals in the spray tank at night and then spray
in the morning. This would lead to separation of
the chemicals and possible damage to the sprayer
components.
48