Toro Multi Pro WM 41240, Руководство оператора

Страница: 77 / 84

g028423
Figure 106
1. Hairpin (5/32 x 2-5/8 inch) 3. Jackstand receiver
2. Clevis pin (1/2 x 4-1/2
inch) 4. Rear jackstand
6. Align the hole in the top of the jackstand with the
hole in the frame of the tank skid (
Figure 106 )
7. Secure the jackstand to the receiver and the
frame with 2 clevis pin (1/2 x 4-1/2 inch) and 2
hairpins (5/32 x 2-5/8 inch) as shown in
Figure
106 .
8. Repeat steps 7 through 7 for the front and rear
jackstands at the other side of the tank skid.
Removing the Sprayer Skid
1. Lower booms to approximately 45° and then
pivot them forward (
Figure 107 ).
g028736
Figure 107
2. Remove the 2 bolts (1/2 x 1-1/2 inches) and
a 2 locknut (1/2 inch) that secure the hold
down bracket of the tank skid assembly to the
bed bracket on the frame at each side of the
machine; refer to
11 Lowering the Tank Skid
(page 25) .
3. Raise the tank skid with the lift cylinders, install
the cylinder lock, and perform the following:
Note:
Refer to Raising the Tank Assembly
(page 60) .
•
For HD- and HDX-Series Workman models
with a manual transmission, disconnect the
PTO shaft from the transaxle PTO; refer
to the installation instructions for the Multi
Pro WM Turf Sprayer Finishing Kit, Manual
Workman Utility Vehicle.
•
For HDX Workman with a automatic
transmission, disconnect the hoses at the
high-flow hydraulic panel and cap the fittings;
refer to the installation instructions for the
Multi Pro WM Turf Sprayer Finishing Kit,
Automatic Workman Utility Vehicle.
•
Disconnect the speed sensor wiring;
refer to
Connecting the Speed Sensor
Harness (HD-Series Models with a Manual
Transmission) (page 20)
and Connecting the
Speed Sensor Harness (HDX-Auto Model)
(page 21)
.
4. Remove the cylinder lock and lower the tank
skid with the lift cylinders; refer to
Lowering the
Tank Assembly (page 61) .
5. Attach the lifting equipment to the horizontal
tubes of the forward jackstands and the vertical
post of the rear jackstands (
Figure 107 ).
6. Lift the tank assembly 7.5 to 10 cm (3 to 4
inches), and remove the lynch pins and clevis
pins securing the lift cylinders to the tank
assembly.
7. Lift the tank skid from the machine high enough
to clear the skid from the machine (
Figure 107 ).
8. Carefully move the vehicle forward and away
from the tank skid.
9. Slowly lower the skid tank to the ground.
77