Toro Multi Pro WM 41240, Руководство оператора

Страница: 19 / 84

5
Installing the Tank Skid
Parts needed for this procedure:
1 Tank and skid assembly
2 Clevis pins
2 Tapered clevis pin
2 Hairpins
4 Lynch pins
2
Bolt (1/2 x 1-1/2 inches)
2 Nuts (1/2 inch)
Procedure
DANGER
The sprayer tank assembly represents a
stored energy hazard. If not properly retained
when installing or removing the assembly,
it can move or fall and injure you or other
bystanders.
Use straps and an overhead lift to support
the sprayer tank assembly during installation,
removal, or any maintenance when the
retaining fasteners are being removed.
1. Using a lift, raise the tank skid assembly ( Figure
10 ) and position it over the vehicle frame with
the pump and valve assemblies facing rearward.
Note:
Have another person help you perform
the following steps.
g023738
Figure 10
1. Rear lift point 2. Front lift point
2. Position the drain valve as follows:
A. At the left side of the tank, loosen the 2
flanged-head bolts that secure the drain
valve to the valve-support bracket (
Figure
11 ).
g028856
Figure 11
1. Valve-support bracket 3. Drain valve
2. Flanged-head bolt
B. Move the drain valve fully outward in the
slots of the bracket (
Figure 11 ).
Note:
Ensure that the drain hose at the
inboard side of the sprayer skid is not
kinked.
C. Tighten 2 flanged head bolts ( Figure 11 ).
3. Slowly lower the tank skid onto the frame of the
machine.
4. Extend the lift cylinders to the brackets on the
tank skid, and align the cylinder fittings with the
holes in the tank skid brackets (
Figure 12 ).
g022353
Figure 12
1. Hairpin 3. Lift cylinders
2. Clevis pin
5. Secure the tank skid to the lift cylinders with
the clevis pins and hairpins at both sides of the
machine.
6. Line up the holes in the pivot lugs at the rear
of the tank skid assembly with the holes in the
19