Toro Multi Pro 41394, Руководство оператора

Страница: 87 / 96

4. Prepare rust inhibiting, non-alcohol based,
RV antifreeze solution; refer to
Preparing the
Conditioner (page 44) .
5. Remove the tube from the back of the pressure
gauge and place the end of the tube into a
container (
Figure 124 ).
g276304
Figure 124
1. Pressure-gauge tube 3. Pressure gauge
2. Tube coupler
6. Start the engine and lower the outer booms
sections.
Conditioning the Sprayer
1. Run the spray pump for a few minutes to
circulate the RV antifreeze throughout the spray
system and any installed spray accessories.
2. Turn the left, center, and right section switches
to the O
N
position.
3. Turn the master section switch to the O
N
position
and look for the following:
•
Ensure that RV anti-freeze flows from the
disconnected end of the pressure-gauge
tube.
•
Spray out the nozzle until the RV anti-freeze
is visible.
4. Turn the master section switch to the O
FF
position.
5. Turn the pump switch to the O
FF
position.
6. Use the boom-section lift switches to raise the
outer boom sections.
Raise the boom sections until they have moved
completely into boom-transport cradle forming
the “X” transport position and the lift cylinders
are fully retracted.
Note:
Make sure that the lift cylinders are fully
retracted to prevent actuator rod damage.
7. Shut off the engine.
8. Drain the sprayer tank as completely as
possible.
Long-Term Storage
(Longer than 30 days)
Perform the following procedures found in Short-Term
Storage (page 86) :
1. Cleaning the Exterior of the Machine (page 86)
2. Preparing to Condition the Sprayer (page 86)
3. Conditioning the Sprayer (page 87)
In addition, perform the procedures that follow:
1. Servicing the Chassis (page 87)
2. Service the Sprayer (page 87)
3. Servicing the Engine (page 88)
4. Servicing the Fuel System (page 88)
5. Servicing the Battery (page 88)
6. Protecting the Machine (page 88)
Servicing the Chassis
1. Check the air pressure in the tires; refer to
Checking the Tire Air Pressure (page 23) .
2. Check the brakes; refer to Adjusting the Brakes
(page 70) .
3. Check and tighten all bolts, nuts, and screws.
Note:
Repair or replace any parts that are worn
or damaged.
4. Paint all scratched or bare metal surfaces
(paint is available from your authorized Toro
distributor).
Service the Sprayer
1. Clean the agitation valve and the 3 section
valves; refer to
Cleaning the Agitation and
Section Valves (page 79) .
2. Grease the sprayer; refer to Greasing the Spray
Pump (page 53) .
87