Toro Multi Pro 41394, Руководство оператора

Страница: 43 / 96

and housing with the retainer that you removed
in step
2 .
Cleaning the Pressure Filter
Service Interval: Before each use or daily—Clean
the pressure filter. Clean the
pressure filter (more often when
using wettable powders).
1. Park the machine on a level surface, engage the
parking brake, shut off the sprayer pump, shut
off the engine, and remove the key.
2. Align a drain pan under the pressure filter
(
Figure 53 ).
g028235
Figure 53
1. Filter head 4. Bowl
2. Gasket (bowl) 5. Gasket (drain cap)
3. Filter element 6. Drain cap
3. Rotate the drain cap counterclockwise and
remove it from the bowl of the pressure filter
(
Figure 53 ).
Note:
Allow the bowl to drain completely.
4. Rotate the bowl counterclockwise and remove
the filter head (
Figure 53 ).
5. Remove the pressure filter element ( Figure 53 ).
6. Clean the pressure filter element with clean
water.
Important:
Replace the filter if it is damaged
or cannot be cleaned.
7. Check the gasket for the drain plug (located
inside the bowl) and the gasket for bowl (located
inside the filter head) for damage and wear
(
Figure 53 ).
Important:
Replace any damaged or worn
gaskets for the plug, bowl, or both.
8. Install the pressure filter element into the filter
head (
Figure 53 ).
Note:
Ensure that the filter element is firmly
seated into the filter head.
9. Install the bowl onto the filter head, and tighten
by hand (
Figure 53 ).
10. Assemble the drain cap onto the fitting at the
bottom of the bowl, and tighten the cap by hand
(
Figure 53 ).
Cleaning the Nozzle Filter
1. Park the machine on a level surface, engage the
parking brake, shut off the sprayer pump, shut
off the engine, and remove the key.
2. Remove the nozzle from the spray turret ( Figure
54 ).
g209504
Figure 54
1. Spray turret 3. Nozzle
2. Nozzle filter
3. Remove the nozzle filter ( Figure 54 ).
4. Clean the nozzle filter with clean water.
Important:
Replace the filter if it is damaged
or cannot be cleaned.
5. Install the nozzle filter ( Figure 54 ).
Note:
Ensure that the filter is fully seated.
6. Install the nozzle onto the spray turret ( Figure
54 ).
43