Toro Multi Pro 41394, Руководство оператора

Страница: 36 / 96

Guide for the Multi Pro 5800-D and 5800-G turf
sprayer with ExcelaRate spray system.
Note:
When you move to a different job site,
you need to select another sub-area screen
to record the individual area and volume
information.
6. If you need to switch the active rate between
the rate 1 value and the rate 2 value, from the
InfoCenter home screen press buttons 1 and 2
simultaneously to select
RATE
1 or press buttons
4 and 5 simultaneously to select
RATE
2; Refer
to the Software Guide for the Multi Pro 5800-D
and 5800-G turf sprayers with ExcelaRate spray
system.
7. Set the spray section switch(es) to the O
N
position ( Figure 41 ).
g192944
Figure 41
1. Left spray-section switch 3. Right spray-section switch
2. Center spray-section
switch
4. Master section switch
8. Set the agitation switch and the spray-pump
switch to the O
N
position ( Figure 42 ).
g192636
Figure 42
1. Sprayer-pump switch 3. Throttle
2. Agitation switch
9. Set the throttle to the F
AST
position ( Figure 42 ).
10. Drive at the desired speed and then set the
master section switch to the O
N
position to begin
spraying ( Figure 41 ).
Note:
Use the master section switch to start
and stop the flow of chemical s to the selected
spray sections.
11. When finished spraying, set the master section
switch to the O
FF
position to turn off all spray
sections, then set the spray-pump switch to the
O
FF
position.
Note:
Raise the outer spray sections to the
transport position and drive the sprayer to the
cleaning area.
Important:
Always raise the boom sections
until they have moved completely into
section-transport cradle forming the “X”
transport position and the lift cylinders
are fully retracted whenever you move the
sprayer from 1 spraying area to another, or
move to a storage or cleaning area.
Spraying in the Manual Mode
Note:
This procedure assumes that the spray pump
is on; refer to Figure 42 in Spraying in the Application
Rate Mode (page 35) .
1. Ensure that the sprayer system is adjusted for
the active spray nozzles that you have selected;
refer to
Calibrating the Section-Bypass Valves
(page 28) .
2. Set the sprayer mode button to the Manual
Mode (
Figure 43 ).
36