
g015917
Figure 9
1.
Large 90-degree elbow
(install at angle shown)
5.
Small 90-degree tee
(install at angle shown)
2.
Strainer
6.
Remove the small plug.
3.
Remove the large plug.
7.
45 degrees
4.
Hydraulic tank
5
Installing the Coupler
Bracket to the Rear Frame
Parts needed for this procedure:
1
Retainer bracket
2
Muffler clamp
1
Hose-retainer bracket
1
Coupler bracket
Procedure
Note:
Install all hydraulic lines loosely first and then
tighten them when everything is installed.
1.
Position the clamps around the round tube of
the rear frame.
2.
Install the hose-retainer bracket and the coupler
bracket to the muffler clamps.
Note:
Do not tighten the nuts at this time. The
coupler bracket needs to be loose to install the
hydraulic lines (
).
g003578
Figure 10
1.
Muffle clamp
4.
Retainer bracket
2.
Muffler bracket
5.
Nut
3.
Coupler bracket
6.
Rear frame round tube
3.
Temporarily position the coupler bracket on the
round frame tube; refer to
.
Note:
Place the coupler bracket where the tube
begins to bend.
g003837
Figure 11
1.
Round frame tube
3.
Coupler bracket
2.
Temporary position for the
coupler bracket
7