
Procedure
Description
Qty.
Use
Large hydraulic hose
1
Hydraulic hose with fittings
1
Large hose clamp
2
Small hose clamp
2
Small molded hydraulic hose
1
R-clamp
1
Bolt (5/16 x 7/8 inch)
1
10
Flange nut (5/16 inch)
1
Install the hydraulic hoses.
11
No parts required
–
Tighten all connections.
Harness
1
Switch
1
12
Fuse
1
Install the switch and harness.
Dipstick
1
13
Hydraulic fluid
25.5 L
(6-3/4 US
gallons)
Install the hydraulic fluid and check for
leaks.
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Lower the attachments.
3.
Engage the parking brake.
4.
Shut off the engine and remove the key.
5.
Thoroughly clean the machine. Remove all
debris to ensure that the mounting brackets will
fit properly and that no dirt or debris gets into
the hydraulic system.
2
Removing the Air Cleaner
No Parts Required
Procedure
1.
Thoroughly clean the area around the air
cleaner.
2.
Loosen the radiator clamp around the hose and
lower the clamp onto the hose.
3.
Remove the inside bolt holding the air cleaner
in place.
4.
Remove the air-cleaner cover and filter (
g003574
Figure 2
1.
Air-cleaner canister
3.
Canister cover
2.
Air filter
5.
Remove the hose from the air-cleaner canister.
6.
Spread the air-cleaner strap open and pull it
over the end of the canister where the filter was
taken out (
).
4