Toro 08781, Руководство по установке, Страница: 10 / 20

g015919
Figure 17
1. Hydraulic line number 1 4. Hydraulic line (hose)
number 5
2. Coupler bracket 5. Hydraulic cap
3. Lower male coupler
8
Installing the Hydraulic
Pump
Parts needed for this procedure:
1 Hydraulic pump
1 45-degree fitting (male ends)
1 Hub assembly
1 Square key (1/4 x 1 inch)
4 Setscrew (5/16 x 3/4 inch)
1 Pump bracket
2 Bolt (with thread-locking compound) (5/16 x 3/4 inch)
2 Washer (3/8 inch)
1 Large 90-degree elbow (with hose barbed end)
Procedure
1. Install the large square 90-degree elbow to the
side of the hydraulic pump.
2. Install the 45-degree elbow to the side of the
hydraulic pump (
Figure 18 ).
g003611
Figure 18
1. 45-degree elbow 4. Male end
2. Hydraulic pump 5. Female end
3. Large 90-degree elbow
(with hose barbed end)
3. Remove the existing cover over the engine PTO
(power takeoff).
4. Install the pump bracket to the engine with 2
bolts (5/16 x 3/4 inch) and 2 washers (3/8 inch).
Refer to
Figure 19 for the correct position to
install the pump bracket.
g003818
Figure 19
1. Engine 4. Washer (3/8 inch)
2. Engine PTO shaft 5. Bolt (5/16 x 3/4 inch)
3. Pump bracket
5. Apply anti-seize compound to the engine PTO
(power takeoff) shaft and the hydraulic motor
shaft.
6. Install the square key (1/4 x 1 inch) into the slot
in the engine PTO shaft (
Figure 20 ).
10