Toro 08781, Руководство по установке, Страница: 13 / 20

g003582
Figure 26
1. Hydraulic tank 4. Hydraulic line number 3
2. Coupler bracket 5. Machine frame
3. Large 90-degree elbow
installed in tank
10
Installing the Hydraulic
Hoses
Parts needed for this procedure:
1 Large hydraulic hose
1 Hydraulic hose with fittings
2 Large hose clamp
2 Small hose clamp
1 Small molded hydraulic hose
1 R-clamp
1 Bolt (5/16 x 7/8 inch)
1 Flange nut (5/16 inch)
Procedure
Note:
Make sure that nothing rubs against any hoses.
1. Slide the 2 large hose clamps onto the large
hydraulic hose.
2. Install the large hydraulic hose to the 90-degree
elbow installed to the side of the hydraulic pump
(
Figure 27 and Figure 31 ).
3. Tighten a hose clamp around the hose and
elbow (
Figure 27 ).
4. Install the large hydraulic hose to hydraulic line
number 3 (
Figure 27 ).
5. Tighten the hose clamp around the hose and
hydraulic line number 3 (
Figure 27 ).
g003614
Figure 27
1. Hydraulic line number 3 4. Hydraulic pump
2. Hose clamp 5. 90-degree elbow
3. Large hydraulic hose 6. Hose clamp
6. Install an R-clamp onto the large hydraulic hose
as shown in
Figure 28 .
g003615
Figure 28
1. Nut (3/8 inch) 3. Bolt (3/8 x 3/4 inch)
2. R-clamp 4. Retainer bracket
7. Install the R-clamp to the retainer bracket with a
bolt (5/16 x 7/8 inch) and a nut (5/16 inch); refer
to
Figure 28 .
13