Toro 03674, Руководство оператора

Страница: 16 / 76

Installing the Rear Cutting Units to
the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch)
or Higher Height of Cut
1. Slide a cutting unit under the lift arm ( Figure 17 ).
g375252
Figure 17
1. Cap 3. Pivot yoke
2. Snapper pin 4. Carrier frame shaft
2. Assemble the pivot yoke onto the carrier frame
shaft.
3. Assemble the cap to the pivot yoke and align
the holes in the carrier frame shaft, pivot yoke,
and cap.
4. Secure the pivot arm shaft and cap to the carrier
frame shaft with the snapper pin.
Locking the Cutting-Unit Pivot for Cutting
Grass on a Hill Side
—Lock the cutting-unit
pivots to prevent the cutting units from rotating
downhill when cutting across the face of a hill.
Use the hole in the pivot yoke (
Figure 17 ) to
lock the cutting unit. Use the slot for a steering
cutting unit.
g375251
Figure 18
1. Snapper-pin positions 3. Slot (pivot yoke)
2. Hole (pivot yoke)
5. Repeat steps 1 and 2 for the other rear cutting
unit.
Installing the Rear Cutting Units to
the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch)
or Lower Height of Cut
1. Remove the lynch pin and washer securing the
to the pivot yoke to the lift arm, and slide the
shaft out of the lift arm (
Figure 19 ).
g375236
Figure 19
1. Lynch pin 3. Lift arm (rear cutting unit)
2. Pivot yoke 4. Washer
2. Assemble the pivot yoke onto the carrier frame
shaft (
Figure 20 ).
16