Important:
Make sure that the reel-motor
cable is not twisted, kinked, or at risk of
being pinched.
g027140
Figure 24
1.
Reel-drive motor
2.
Mounting bolt (2)
4.
Rotate the motor counterclockwise until the
flanges encircle the bolts.
5.
Torque the mounting bolts to 19 to 25 N∙m (14
to 18 ft-lb).
6.
Repeat steps
through
at the other cutting
units.
4
Mounting the Finishing Kits
Parts needed for this procedure:
1
Finishing kit (sold separately)
Procedure
Important:
To ensure that the electrical cable
routing is appropriate and the cables are not
twisted, mount the motors to the cutting units
before mounting the finishing kits.
Use the following diagram to determine the
positions of cutting units and reel motors.
g316995
Figure 25
1.
Center front cutting unit
4.
Front left cutting unit
2.
Left rear cutting unit
5.
Front right cutting unit
3.
Right rear cutting unit
6.
Reel motor location
1.
On the front left corner of the frame (#4 cutting
unit location), remove the extra flange nut on
the bolt securing the bulkhead bracket to the
machine (
).
2.
Loosen the nuts on the finishing kit hose fitting,
insert the hose into the slot on the bulkhead
bracket and tighten the nuts.
Note:
When tightening the nuts, use a backup
wrench to prevent the hose from twisting or
kinking.
3.
Insert the connector plate onto the
bulkhead-mounting bolts with the connectors
positioned as shown in
.
4.
Secure the connector plate to 1 of the mounting
bolts with the flange nut previously removed.
5.
Locate the wire harness on the machine and
plug the wire connectors into the wire connectors
of the finishing kit.
18
