g375694
Figure 13
1.
Flange locknut (3/8 inch)
3.
Capscrew
2.
Right tab (Carrier frame)
5.
Align the holes in the turf-compensator bracket
with the holes in the cutting-unit frame (
Note:
The support loop of the hose guide aligns
toward the centerline of the machine.
g378789
Figure 14
1.
Turf-compensator bracket
3.
Flange locknut (3/8 inch)
2.
Carriage bolt (3/8 x 1-1/4
inches)
4.
Inboard
6.
Assemble the turf-compensator bracket to the
cutting-unit frame with the 2 carriage bolts (3/8 x
1-1/4 inches) and 2 flange locknuts (3/8 inch).
7.
Torque the locknuts and bolts to 37 to 45 N∙m
(27 to 33 ft-lb).
8.
Repeat steps
through
for the other cutting
unit.
Installing the Front Cutting Units
to the Lift Arms
1.
Slide a cutting unit under the lift arm (
).
g375274
Figure 15
1.
Cap
3.
Pivot yoke
2.
Snapper pin
4.
Carrier frame shaft
2.
Assemble the pivot yoke onto the carrier frame
shaft.
3.
Assemble the cap to the pivot yoke, and align
the holes in the carrier frame shaft, pivot yoke,
and cap.
4.
Secure the cap and the carrier-frame shaft to
the pivot yoke with the snapper pin.
Locking the Cutting-Unit Pivot for Cutting
Grass on a Hill Side
—Lock the cutting-unit
pivots to prevent the cutting units from rotating
downhill when cutting across the face of a hill.
Use the hole in the pivot yoke (
) to
lock the cutting unit. Use the slot for a steering
cutting unit.
g375251
Figure 16
1.
Snap-pin positions
3.
Slot (lift-arm pivot shaft)
2.
Hole (lift-arm pivot shaft)
15
