Toro 03674, Руководство оператора

Страница: 24 / 76

g003955
Figure 41
1. Traction pedal 4. Brake pedal
2. Mow/transport lever 5. Parking brake
3. Mow-speed limiter and
spacers 6. Tilt steering pedal
Mow/Transport Lever
Use the mow/transport lever ( Figure 41 ) to put the
machine into M
OW
mode or T
RANSPORT
mode. Push
the lever forward to select the M
OW
mode, and
backward to select the T
RANSPORT
mode.
Note:
The cutting units cannot be lowered when the
mow/transport lever is in the T
RANSPORT
position.
Mow-Speed Limiter
When the mow-speed limiter ( Figure 41 ) is flipped
up/forward it limits the mow speed and allow the
cutting units to be engaged. Each spacer adjusts
the mowing speed by 0.8 km/h (0.5 mph). The more
spacers there are on the top of the bolt, the slower the
machine goes. Flip the mow speed limiter backward
to allow maximum transport speed.
Brake Pedal
Press the brake pedal ( Figure 41 ) to stop the machine.
Parking Brake
To engage the parking brake, ( Figure 41 ) push down
on the brake pedal and press the top forward to latch
it. To release the parking brake, press the brake pedal
until the parking-brake latch retracts.
Tilt-Steering Pedal
To tilt the steering wheel towards you, press the foot
pedal (
Figure 41 ) down, pull the steering tower toward
you to the most comfortable position, and release the
pedal.
Engine-Speed Switch
The engine-speed switch has 2 modes to change the
engine speed (
Figure 42 ). By momentarily tapping the
switch, you can change the engine speed in 100 rpm
increments. If you hold the switch down, the engine
automatically moves to High or Low idle, depending
on which end of the switch you press.
g021208
Figure 42
1. Lower mow/raise control
lever 4. Enable/disable switch
2. Key switch 5. Engine-speed switch
3. InfoCenter 6. Headlight switch
Lower Mow/Raise Control Lever
This lever ( Figure 42 ) raises and lowers the cutting
units and also starts and stops the cutting units when
the cutting units are enabled in the M
OW
mode. You
cannot lower the cutting units when the mow/transport
lever is in the T
RANSPORT
position.
Key Switch
The key switch ( Figure 42 ) has 3 positions: O
FF
,
O
N
/P
REHEAT
, and S
TART
.
InfoCenter
The InfoCenter LCD display shows information about
your machine, such as the operating status, various
diagnostics, and other information about the machine
(
Figure 42 ).
24