Toro 03674, Руководство оператора

Страница: 17 / 76

g375237
Figure 20
1. Cap 3. Pivot yoke
2. Snapper pin 4. Carrier frame shaft
3. Assemble the cap to the pivot yoke, and align
the holes in the carrier frame shaft, pivot yoke,
and cap.
4. Secure the pivot yoke and cap to the carrier
frame shaft with the snapper pin.
Locking the Cutting-Unit Pivot for Cutting
Grass on a Hill Side
—Lock the cutting-unit
pivots to prevent the cutting units from rotating
downhill when cutting across the face of a hill.
Use the hole in the pivot yoke (
Figure 21 ) to
lock the cutting unit. Use the slot for a steering
cutting unit.
g375251
Figure 21
1. Snapper-pin positions 3. Slot (pivot yoke)
2. Hole (pivot yoke)
5. Slide a cutting unit under the lift arm ( Figure 22 ).
g375239
Figure 22
1. Lynch pin 3. Lift arm
2. Lift-arm shaft 4. Washer
6. Insert the pivot yoke into the lift arm, and secure
shaft to the arm with the lynch pin and washer.
7. Repeat steps 1 through 6 for the other rear
cutting unit.
Installing the Cutting Unit Lift-Arm
Chains
Secure the lift-arm chain to the chain bracket with the
snapper pin (
Figure 23 ).
Note:
Use the number of chain links described in the
cutting unit Operator's Manual .
g003948
Figure 23
1. Lift-arm chain 3. Snapper pin
2. Chain bracket
Assembling the Reel Motors to the
Cutting Units
1. Apply a coat of clean grease to the splines of the
reel-motor shaft.
2. Apply a coat of oil the reel motor O-ring and
install it onto the motor flange.
3. Align the motor to the cutting unit so that the
motor flanges clear the bolts clockwise (
Figure
24 ).
17