INSTALLATION MANUAL
Configure HyperTerminal for the respective COM ports and 8-N-1 communication parameters:
Then the HyperTerminal screen opens up:
Pick up the phone (“call”) to connect.
The status bar at the bottom of the screen will show the successful connection to Voxell LCR ;
Type the command “AT” to place the modem in data transfer mode. Be careful to use capital
letters, and no spacing between AT and the three zeroes!
Alternate command – AT is the normal command, which sets the modem of Voxell LCR in data
mode if the modem is registered and free (not busy with a voice call or SMS message). But there is
an alternate command, which forces the modem to go into data mode, no matter which state it is
in.
This forced command is “AT001”.
Note: Remember that you have to memorize
the name of the Voxell LCR modem and the port,
because you gone use this information when you will perform the Dial-Up connection. Also, the
same COM port number will be used for the connection to the OAM program.
page 28 / 60