INSTALLATION MANUAL
)
The antenna will be threaded to RF connector available on Voxell LCR (FME male
type). This RF connector is on the top side of equipment, the antenna attachment
will be done as is shown in the picture bellow.
Figure 6.: Antenna attachment
0
Don’t force the fastening of antenna; screw the antenna manually (by hand only). Using a
pairs of pliers may lead to damage of antenna thread.
When you install the antenna, be carefully that the chosen place to be suited for the best
reception of signal for to the mobile network.
The stick antenna has vertical polarization, so they should be placed in vertical or horizontal
position, depending of the local field condition.
The table below shows the main characteristics of the multi-band stick antennas with
magnetic base (currently supplied with the Voxell LCR package).
Frequency bands
GSM 890-960 MHz
PCN 1710-1880 MHz
PCS 1850-1990 MHz
UMTS/HDSPA 1920-2170 MHz
Gain 2
dBi
Polarization Vertical
Height
Total 73 mm, Active stick 43 mm
Base
Magnetic, diameter 2,8cm
Cable
Type RG174, length 2,5 m
End Connector
Nipple, male
Note:
The Voxell LCR and its antenna should be placed as far as possible from appliances or office
equipment that is sensitive to radio interference (microwave ovens, copiers, TV sets, PC
displays, and multimedia systems). For best results, try to find a place of maximum signal
reception for the Mobile antenna
In addition, the antenna must NOT be located near heavy-duty equipment that may generate
electromagnetic interferences, such as electric motors or heaters.
page 17 / 60