Topcon Pocket-3D, Справочное руководство, Страница: 87 / 316

Station Setup
P/N 7010-0628
2-41
2. On the
control points
dialog box, do the following:
•
Add
– press to add point/control points to the resection. The
Backsight results
dialog box (Figure 2-57 on page 2-42)
displays.
•
Edit
– press to edit a highlighted point/control point, then
press
Ok
to return to the
control points
dialog box.
Figure 2-56. New Station by Resection Setup Method
•
Delete
– press to delete a highlighted point/control point on
the
control points
dialog box, then press
Ok.
Press
Yes
to confirm or No to cancel.
On the
Backsight results
dialog box (Figure 2-57 on page 2-42),
select or enter the following parameters:
• Filter List – select either Control points or Point from the drop-
down list.
• Layer – select a layer file from the drop-down list, if Points was
selected from the Filter List.
• Name – select the control point to be used in the resection from
the drop-down list.
NOTE
You can use any number of points, but at least 3
points should be used for an accurate resection.
Once computed, add the new, resected point to the
control point file.
Control Points dialog
Setup Method dialog box