TNI softFlow 50, Руководство по эксплуатации

Страница: 9 / 56

9
Operating Instruction TNI soft Flow 50 homecare system
• The sensor connection located below the carrying handle of the TNI
soft
Flow
50
may only
be used to connect the “external temperature measuring element” (item no. 40641018) or
other components authorized by the TNI medical AG. Do not connect unauthorized com-
ponents to this socket!
• Please make sure that the device is positioned in a way that the power plug can be discon-
nected without difficulties.
• An SD-Card can be used to store information independently from the device.
1.3.5) Environmental conditions
• The TNI
soft
Flow
50
may only be operated under admissible ambient conditions (see
chapter 7, “ Technical Data ”). Operating the device under ambient conditions out of the
range defined for the guaranteed performance parameters will result in reduced perfor-
mance parameters. If the ambient conditions are out of the given range, the device should
stay in off-mode due to safety reasons.
In order to ensure proper use, it is important to let the TNI
soft
Flow
50
adapt to the ambi-
ent conditions (room temperature). Please wait about 2-4 hours before starting up the de-
vice. This applies to the first usage of the TNI
soft
Flow
50
and to transporting the device,
i.e. the transport conditions were out of the given range of ambient conditions. Do not use
the device in humid and potentially explosive rooms or combustible atmosphere.
• Intended functioning of the TNI
soft
Flow
50
may be impaired when it is operated right
next to HF electrosurgery devices, defibrillators, X-rays, transmitted pulses, radio frequency
interference or devices designed for short wave therapy.
• Do not use the TNI soft Flow 50 while performing the measures mentioned above or dur-
ing magnetic resonance tomography (MRT, NMR, NMI).
• Active mobile phones may only be placed next to the device when a minimum distance of
1m is being kept.
• The system must not be set up next to a heater and must not be exposed to direct sunlight
since this may interfere with a proper operation of the device.
• The sensor measuring the ambient temperature is located on the right in the inside of the
device. Do not point any source of heat (e.g. heater,...) towards this sensor.
• In order to ensure a sufficient air circulation around the device, a minimum distance of 25
cm to all sides is to be kept.
• The device may not be covered.
• To avoid a fast accumulation of dust in the air filter, do not place the TNI
soft
Flow
50
near
the ground.
• The device is intended to be used indoor and should be placed on an even horizontal
surface.
• To avoid damage, contamination or malfunctioning, place the device out of reach from
pets, pests or children
• Operating the device at a low ambient air temperature may result in a formation of conden-
sate in the applicator. Keep the boxed applicator away from direct sunlight and store it in a
dry place.