15 |
P a g e
Tigo Energy, Inc.
|
www.tigoenergy.com
|
3)
Insert sleeve anchors in the pilot holes and assemble the
anchor. Secure bolt and washers against the mounting tabs
to secure to the wall.
Removing the front cover
Tools needed: #2 Philips head screwdriver
1)
Remove the lower
base plate
(
11
) and 6
screws (3 from each side) securing the
front
cover
(
9
). Unlatch the two front cover locks
from the bottom, as shown.
2)
Tilt cover up and CAREFULLY swing the front cover to the left, using caution to not pull
ground or display wires.
CAUTION!
The front cover has a grounding wire and
display cable attached to the interior. Use
caution and detach wires before carefully
attempting to remove the cover.
Figure 12 Securing the EI Battery
Figure 13 Base plate removal
Figure 14 Front cover removal
