110
ü
ü
ü
üü
ü
ü
ü
Checking and replacing
fuses
In the event that the front lamp or
other electric appliances fail to
work, please check the fuse. If the
fuse has been burnt, please replace
it with new quaility fuse.
Please turn off the ignition switch
and other idled electric appliances,
and then directly take off the fuse
for check.
Confirm the fuse in problem, and
mark the name of the electric circuit
where the fuse is located on the fuse
box. Please see Chapter VIII of the
Manual for the electric appliances
controlled by every fuse.
Type A fuse can be taken out by
special tool that was placed in fuse
box in the engine compartment.
In the event that you are not sure if
the fuse has been burnt, please
replace a fuse that you considered
intact.
If the fuse has been burnt, please
insert a new one into original slot.
Only the fuse meeting the current
stipulated on the fuse box can be
installed.
In the event that there is no spare
fuse, please take out the fuse at A/C
in case of emergency, and such fuse
is not necessary in normal drive, but
it can be used if its current meets
requirements.
If the fuse of the same model and
size cannot be found, the fuse with
relatively small rated current can be
used, but it shall meet original rated
current. If the new one’s current is
much lower than the rated current,
the fuse may be burnt again; thus
fuse meeting requirements shall be
immediately
found
for
the
installation.
Users should purchase one set of
spare fuse and put it in the vehicle
for emergency.
If the new fuse has been burnt
immediately, the power system
Type A
Intact
Burnt
Type B
Intact
Burnt
Type C
Intact
Burnt
112
