Thermo Scientific thermoscientific Vanquish UHPLC System, Руководство по эксплуатации

Страница: 50 / 148

5 • Installation
Page 50 UHPLC System
Operating Manual
9. Connect the waste lines (see Connecting the Waste Lines
(
}
page 70) ).
10. Attach the column compartment to the system stack (see next
section).
NOTICE
Some modules have shipping locks. To avoid damage to the system
when the system is turned on, loosen them or remove them properly.
Refer to the
Operating Manual for each module for information on
shipping locks that need to be removed.
5.4.1.2 Attaching the Column Compartment to the System Stack
TIP
Before you attach the column compartment to the system, connect the
waste line to the system drain port. For instructions, see
Connecting the
Waste Lines ( } page 70) .
In the standard configuration, the Vanquish system includes one column
compartment, installed to the right side of the system.
TIP An extended or left-side configuration of the column compartment is
also available. Observe the following notes:
• The extended configuration on the right side can include up to three
column compartments. For the extended configuration of the
column compartment, up to two conversion kits are required.
• The column compartment can also be installed to the left side of the
Vanquish system stack. For the left-side installation, one column
compartment requires one conversion kit. Each additional column
compartment on the left side requires an additional conversion kit. If
a Vanquish Charger is used with the Vanquish system, the column
compartment must be attached to the right side of the system.
• For ordering information, contact your local Thermo Fisher Scientific
sales organization.
Installation by Service Engineer only
Only service personnel certified by Thermo Fisher Scientific are
permitted to install the extended configuration with up to three column
compartments or to perform the left-side installation of the column
compartment.