Thermo Scientific Barnstead GenPure xCAD Plus System, Руководство по эксплуатации

Страница: 62 / 128

10
Putting system into operation
Dispensing water from the dispensing valve
56
GenPure Thermo Scientific
Dispensing water from the dispensing valve
Venting the 0.2 — m final filter
Press this button to switch the system on. After a compulsory rinse, the system switches into the
“Interval” mode.
Vent the system by switching it to “Rinsing” three times in succession and, during
this procedure, withdraw approximately 5 liters of water and discard it. The ultrapure
water limiting value may be exceeded during this procedure.
Use the “NONSTOP” button to switch the system to the “Nonstop” operating mode. The system
switches automatically into “Interval” mode after a predetermined time (factory setting 10 min.).
Factory setting can be changed through the OEM-Menu by a service technician.
Step Action Figure
1 To dispense water from the dispensing valve push the dispense
button on the handle once time.
To stop dispense water from the dispensing valve push the
dispensing button on the handle twice time.
Step Action Figure
1 The first time you dispense pure water at the main dispenser
through the 0.2 μm final filter, open the white knurled screw.
Do not close the knurled screw until pure water runs out of the
opening at the knurled screw continuously. Rinse about 500 ml
of water through the final filter.
0.2 μ m
final filter
Knurled
screw