Thermo Scientific Barnstead GenPure xCAD Plus System, Руководство по эксплуатации

Страница: 49 / 128

7
Installation
Installation of an additional xCAD Client, wall version (optional)
Thermo Scientific GenPure
43
3 a. Hold the wall mount bracket at the
desired position on the wall and mark
the four boreholes for fixing the wall
mount bracket.
Then use a 6 mm or 1/4" twist drill to
make the holes and put in the four S6
dowels which are supplied in the
assembly kit.
If you want to take the hoses and cables out of
back the wall look at the pictures 1) and 2) and
step b). When it is not wish going to step 4.
b. Refer to dimensions on picture 1) and 2)
to make the necessary wall cuts needed if
you want to push the 0.31“(8mm) o.d
hoses and cable out through the wall
behind the xCAD.
4 Attach the wall mount bracket to the wall by
screwing in the 4 supplied screws with a philips
screw driver into the wall where you have put in
the plugs before.
Step Action Figure
Boreholes
Wall
Wall
a)
1)
2)
b)
Wall mount
bracket
Wall mount
bracket
Possible wall cut-outs for cable and
hose taken out at back
Philips
screw-
driver
Screw
Wall mount bracket