9-6
Nanopure™ Analytical
Thermo Scientific
Section 9
User Settings
Performing a System
Flush
UP arrow: +0.25 up to 1 L, then 5 L, then incremental by 5 L.
DOWN arrow: Decrement by 1 L until 1 L, then by 0.25 L.
Maximum: 60 L
Minimum: 0.25 L
1. From the normal recirculating mode, when the display is showing
purity, press the UP or DOWN arrow until the display reads, “Auto
Dispense Menu?”
2. Press ENTER.
3. Display will read, “Dispense Method.” Press the UP or DOWN arrow
to select TIME.
4. Press ENTER. Display will read, “Time Setting: xx Minutes.”
5. Press the UP or DOWN arrows to set the desired time value. Press
ENTER.
UP arrow: +1 up to 5 min., then increments by 5 minutes
DOWN arrow: Decrement by 1 minute
Maximum: 40 minutes
Minimum: 1 minute
1. From the normal recirculating mode, when the display is showing
purity, press the UP or DOWN arrow until the display reads, “System
Flush?” Press ENTER.
2. Press the UP or DOWN arrow to select “Short Flush?” or “Extended
Flush?” Press ENTER.
3. Display will read, “System Flushing: (xxx) Seconds or (xxx) Minutes
Remaining.”
Note
Press the STOP/STOP switch to cancel the flush.
s
Setting Volumetric
Dispensing (cont.)
Setting Timed
Dispensing
