Thermo King SGCO 3000, Руководство пользователя

Страница: 76 / 144

Operating Instructions
76
LogView and Viewing SG+ Logs
With the release of LogView software version
5.9.2.0 (or later), you can now view SG+ Event
logs. The following will outline how to interpret
the SG+ log. To understand now to use LogView
refer to the Help file found within LogView.
The SG+ log can store up to 128 Event logs. The
oldest events will be over written in the log
automatically.
With the release of SG+ software 08042300, some
changes were made to the description so the log
may have different wording based on the software
that was in the controller at the time of the
logging. The following shows the latest release
descriptions.
The latest LogView files can be found on our Web
site under Global Marine Solutions Info Central.
NOTE: Logman II PC Rev. 2.4.1 (or later) is
required to flashload software or to download
the data logger.
Event Description
Data ID / Code Description
Alarm Alarm Code An alarm is activated, see “Alarm List” on
page 52 for alarm descriptions
Message Message code A message is activated, see “Message List” on
page 55 for message descriptions
Engine Shutdown alarm If an alarm is active and entering shutdown state
Engine running The engine is running
Restart engine Restart sequence started
Pre trip PTI started PTI start event
PTI failed PTI failed
PTI OK PTI completed
Configuration Factory reset Factory reset initiated by user
Clock set Time and date adjusted
Power Power off Time and date for controller power off
Power on Time and date for controller power on
Log retrieved Log retrieved The event log is retrieved from the unit
Speed High to low speed - was XXX RPM RPM above shift point
Low to high speed - was XXX RPM RPM below shift point
Low to high speed RPM below limit RPM below 1500 RPM
High to low speed MAGNUM unit detected A TK MAGNUM unit is detected
Low to high speed compressor start detected Reefer unit controller is resetting
Low to high speed water temperature to high
Water temperature XXX If water temperature is above 5 C below alarm
high limit
Failed to detect speed solenoid This event is set in the state “LOAD MEAS” if it
fails to detect the speed change
Fuel Positive change from X.X to X.X Ga Change
in level; +X.X Ga Positive fuel change detected
Negative change from X.X to X.X Ga Change
in level; - X.X Ga Negative fuel change detected
System Flashload completed OLD: XXX to NEW:
XXX A new version of the application is loaded