Thermo King SGCO 3000, Руководство пользователя

Страница: 132 / 144

Mechanical Diagnosis
132
Engine stops after starting Alarm LED flashing Check alarm code and repair fault (see
“Alarm List” on page 52)
Vent of fuel tank obstructed Unclog vent
Fuel filter obstructed Replace filter element
Clogged fuel tank or fuel lines Clean fuel tank and fuel lines
Air in injection pump Bleed fuel system
Engine does not develop
full power Air cleaner or intake system clogged Clean air intake system; clean and refill
oil reservoir on oil bath air cleaner; or
replace dry air cleaner filter
Fuel tank vent clogged Unclog vent
Clogged fuel tank or fuel lines Clean fuel tank and fuel lines
Speed adjustment wrong Adjust speed
Insufficient fuel volume leaving filter(s) Check for dirty filter or air in system
Injection pump timing off Adjust timing
Nozzles defective Repair or replace nozzles
Delivery of fuel pump insufficient Repair pump
Worn injection pump plungers, delivery
valve defective, injection rate too low,
gum formations Repair or replace pump
Compression low or unbalanced Overhaul engine
Engine knocks heavily Wrong fuel Change fuel
Air in system Bleed fuel system
Fuel return line plugged Remove return line restriction
Injection nozzles fouled or opening
pressure too low Clean, repair or replace injection nozzles
Valve out of adjustment Adjust valves
Delivery valve spring broken Replace spring or repair injection pump
Injection pump not timed Retime injection pump
Compression too low Overhaul engine
Rod or main bearing worn Replace rod or main bearings
Engine speed too high Mis-adjusted speed screw Adjust speed screw
Control rod sticks Repair injection pump
Engine fails to stop when
unit is Off Fuel solenoid defective Replace solenoid
Injection pump defective Replace pump
Diagnosing Unit Conditions
Condition Possible Cause Remedy