Thermo King SGCO 3000, Руководство пользователя

Страница: 127 / 144

Structural/Accessory Maintenance
127
3. Insert the foot of the mounting clamp fully
into the container mounting hole. Pull lock
pawl handle forward. Pull the clamp handle
down to rotate the clamp shaft bolt 90° and
clamp generator set to container.
4. Release the lock pawl to hold the clamp
handle in the locked (down) position.
5. Check to be sure the generator set frame fits
tightly against the container. Turning the
mounting clamp handle should pull the
generator set frame tight against the container
front wall. If necessary, tighten the mounting
clamp. The mounting clamp can be tightened
or loosened by turning the nut on the head of
the clamp shaft.
CAUTION: Watch the clamp flat on
threaded end of the mounting shaft when
rotating the handle. The clamp flat should
turn as the clamp handle rotates. With the
mounting clamp in the locked position
(handle down), the clamp flat must be
horizontal. If the flat is not horizontal,
check the clamp handle for a broken
shoulder screw.
CAUTION: Excessive vibration or unit
malfunction can occur if mounting
clamps are not properly secured. The
generator set MUST be tight against the
container.
AXA0332
1. Lift (Unlock) Lock Pawl 5. Lift (Unlock) Lock Pawl
2. Rotate Clamp Handle Up 90 degrees 6. Rotate Clamp Handle Down 90 degrees
3. Release (Lower) Lock Pawl 7. Release (Lower) Lock Pawl
4. Insert Mounting Clamp Foot in
Container Mounting Hole 8.
Figure 104: SGCO 3000 Clip-on Corner Clamp Installation Procedure