Thermal Arc A-07360, Руководство по обслуживанию, Страница: 22 / 102

FABRICATOR 210
3-2 June 19, 2006
3.04 Input Power Requirements
The Mains supply voltage should be within ± 10% of the r ated Mains supply voltage. Too low of a supply voltage may
cause poo r welding pe r fo r mance o r wi r efeede r malfunction. Too high of a supply voltage will cause components to
ove r heat and possibly fail.
Install a powe r outlet fo r each Powe r Supply and fit fuses as pe r the machine specifications.
!
WARNING
The r mal A r c advises that you r Fab r icato r 210 be elect r ically connected by a qualified elect r ical t r ades-
pe r son.
The Fab r icato r 210 Powe r Supply is facto r y connected fo r the following input powe r supply voltage:
Input Power
Supply Lead Size
Lead Current
Rating
Lead
Length
Machine
Voltage Setting Duty Cycle
10 AWG 30 Amps 10ft (3m) 230V 1ø 250A @ 30%
Table 3-1: Facto r y Fitted Input Powe r Supply Leads Fitted to the Fab r icato r 210
3.05 Alternative Mains Supply Voltages
!
WARNING
The Fab r icato r 210 input powe r supply lead should be r eplaced with leads as specified in Table 3-2 when
the Fab r icato r s input powe r supply voltage is changed.
The Powe r Supply is suitable fo r use on the following input powe r supply voltages:
Input Power Supply
Voltage Setting
Primary Input
Power Lead Size Lead Length
Input Power
Outlet Size Fuse Size
208V 1ø 10AWG (5mm2) 3M 50 Amps *60Amp
230V 1ø 10AWG (5mm2) 3M 50 Amps *50Amp
Table 3-2: Mains Supply Lead Sizes fo r Alte r native Mains Supply Voltages
*Moto r sta r t fuses o r the r mal ci r cuit b r eake r s a r e r ecommended fo r this application. National Elect r ical Code Standa r ds
pe r mit the r ating of the fuse o r the r mal ci r cuit b r eake r p r otecting the ci r cuit conducto r s to be double the standa r d
r ating fo r any ci r cuit used exclusively fo r an elect r ic a r c welde r . Check local r equi r ements fo r you r situation in this
r ega r d.