TEXIO LSG SERIES, Инструкция по эксплуатации

Страница: 67 / 167

55
2-6-5-2. Trigger Out Width
Description The Trigger Out Width setting sets the
trigger output signal’s pulse width.
Operation
1.
Press
Shift
+
Utility
Help
> Other[F5] .
2.
Set the Trig Out width.
Range: 2.5
– 5000us (Default:10.0us)
2-7. Go-NoGo
The Go-NoGo configuration is used to create pass/fail limits on
the voltage or current input. If the voltage/current exceeds the
pass/fail limits, an alarm will be output.
The Go-NoGo configuration can be used with the Program
function to create complex pass/fail tests.
2-7-1. Setting the Go-NoGo Limits
Description The Go-NoGo setting limits can be set as either
discrete high & low values or as a percentage
offset from a center value.
Operation
1.
Press
Main
> Configure[F5] > Go-NoGo[F3].
2.
Select Entry Mode and choose how to set the
pass/fail limits.

Value will allow you to set the limits as discrete
values.

Percent will allow you to set the limits as a
percentage offset from a center value.
3.
If Entry Mode was set to Value , Set the High &
Low limit values.
High:
Low: 0~rating current/voltage
0 ~rating current/voltage
4.
If Entry Mode was set to Percent , Set the Center
voltage/current and High, Low % values.
Center:
High:
Low: 0~rating current/voltage
0~100% of center voltage/current
0~100% of center voltage/current
5.
Set the Delay Time .

The delay time setting will delay activating the
Go-NoGo testing by a specified amount of time.

The delay setting can compensate for startup
oscillation and other instabilities during startup.
Delay Time 0.0~1.0 seconds (0.1s resolution )